Sears Garage Door Keypad Not Working

The lock button feature disables all remotes.

Sears garage door keypad not working.

A phillips screwdriver and a new 9v battery is all you need for t. Make sure the outlet is switched on if your home has on off switches fitted to its outlets. If the outlet does not work check your home fuses and circuit breakers. Press and hold the lock button for 2 seconds to disable the feature.

If the garage door opener lights blink twice when you press the remote check the wall control to see if you have the lock feature enabled. Test the outlet plugging in a lamp or another appliance into the same outlet. After pressing the learn button on the side of the motor your partner will have 30 seconds to enter the code into the keypad. Set the ladder up near your garage door motor and carefully climb up to the point where you can reach it.

You also must have access to the inside of your garage to perform this garage door keypad repair it won t work if you re locked out if your keypad is closing your garage but not opening it have your partner stand near the keypad. When the garage door opener works intermittently the logic board may be experiencing radio frequency rf interference from nearby sources such as security lights ham radios and some electronics. If the remote works only when held within a few feet of the motor unit rf interference is probably the problem.