Self Closing Door Hinges Instructions

Unscrew the locking screws from the top hinge.

Self closing door hinges instructions.

If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers. If the door closes fast and with a bang you need to loosen the hinge spring tension. Self closing hinges take the place of regular hinges. If you re using one spring.

Using a hex wrench open the spring so you can see the tension pin. Get free shipping on qualified self closing door hinges or buy online pick up in store today in the hardware department. Refer to the specifications that came with your hinges to determine how many spring hinges you need. If the holes align you can simply attach the hinge using the screws it came with.

They allow adjustment so the screen door closes securely without slamming. Changing tension with a hex wrench 1. I ll bet that you never knew you could adjust a self closing door hing. Remove the locking pin.

Close the door completely. Ask a friend to hold your door in. A spring loaded hinge should only be removed when the door is closed to avoid it slamming. Start by removing the locking pin photo 1.

As mentioned previously the door should close smoothly and fully with little noise. You may have to chisel the edge of the door to get a new square cornered hinge to fit in mortises machined for round cornered hinges. Installing a self closing hinge first place the hinges onto the door. Then remove the pin using pliers.

In order to tighten the hinge spring first close the door. Screw the spring hinges to the door so that the slotted section on each hinge is on top. You can then remove the hex wrench and allow the spring to naturally unwind. Then add or release tension until you get the proper close rate photo 2.

Insert a hex wrench into the. Step 2 increase the hinge tension. See if they line up with the nail indents from the previous hinges. If you plan to use self closing hinges take the original middle hinge to your home center or lumberyard and find self closing hinges with plates the same size as the ones already on the door.

Stand on the side of the door with the hinges and shut the door until it latches. If the door does not close fully then you need to increase the tension.